Color-Changing 6 x 9 Solar Paver Light
Color-Changing L shaped Solar Pool Light
Color-Changing Round Solar Deck Light
6x9 Paver Lights Installation Steps
1. Level and clear the ground
Ensure a flat, debris free surface for stable installation.
2. Create 6" x 9" spaces
Remove existing tiles to make room for each light.
3. Position lights upward
Place each solar paver light in the space with the solar panel facing up.
4. Complete the installation
Ensure that the paver lights are firmly embedded in the ground, and then the installation is complete.
Outdoor Step Lights Installation Steps
1. Remove the round magnet
Detach the circular magnet from the base of the solar step light to prepare for adhesive installation.
2. Apply Silicon Glue
Apply silicone adhesive to the designated area on the base to enhance weather resistance and bonding strength.
3. Remove protective film from the double-sided tape
Peel off the protective layer from the pre-installed double-sided tape on the mounting surface.
4. Stick it on the surface
Firmly press and attach the light onto a clean, dry outdoor stair surface, ensuring full contact with the adhesive tape.
Above Ground Pool Lights Installation Steps
1. Peel off the magnetic switch patch
Gently remove the protective backing to expose the adhesive side, taking care not to touch the sticky surface.
2. Apply a small amount of silicone glue
For extra durability (especially on uneven surfaces), add pea sized dots of glue to the mounting area before installation.
3. Install the light on the surface
Align the light with your pre marked position, then press firmly for 30 seconds to ensure full adhesion. Wipe away any excess glue immediately.
Solar Deck Lights Installation Steps
Choose one of the following three installation methods:
1. Burried With Spike
Push the ground peg firmly into the soil for secure anchoring.
2. Grounded With Screw
Secure with screws for stable installation on hard surfaces.
3. Attach With Waterproof Adhesive
Press firmly with a waterproof adhesive to achieve a permanent bond.
4X4 Paver Lights Installation Steps
1. Level and clear the ground
Ensure a flat, debris free surface for stable installation.
2. Create 4" x 4" spaces
Remove existing tiles to make room for each light.
3. Position lights upward
Place each led solar brick in the space with the solar panel facing up.
Solar Porch Lights Installation Steps
1. Remove the back plate
Loosen the bottom screw to remove the back plate from the light fixture.
2. Install the light bulb
Install the light bulb inside the sconce.
3. Mark the screw holes
Carefully mark the spacing of the screws on the wall using the back plate.
4. Drill holes and install plugs
Drill holes on the wall and install the rubber plugs.
5. Secure the back plate
Secure the back plate to the wall with the self-tapping screws.
6. Turn on the power switch
Remember to switch on the light on the back of the lamp.
7. Hang the lamp
Hang the lamp onto the back plate.
8. Secure the lamp
Secure the lamp to the back plate using the screw at the bottom.
Outdoor Solar Wall Lights Installation Steps
1. Remove the back plate
Loosen the bottom screw to remove the back plate from the light fixture.
2. Install the light bulb
Install the light bulb inside the sconce.
3. Mark the screw holes
Carefully mark the spacing of the screws on the wall using the back plate.
4. Drill holes and install plugs
Drill holes on the wall and install the rubber plugs.
5. Secure the back plate
Secure the back plate to the wall with the self-tapping screws.
6. Turn on the power switch
Remember to switch on the light on the back of the lamp.
7. Hang the lamp
Hang the lamp onto the back plate.
8. Secure the lamp
Secure the lamp to the back plate using the screw at the bottom.